About our Tools
Gunline Tools are machined to the highest standards required by
professionals and hobby stockmakers. They have been popular and
distributed throughout the world since 1946. They are noted for easy
handling, accuracy, precise fit of components and durability. Sample
patterns and clear instruction showing various layout styles are included
in the sets. It is easy for anyone of craftsman ability to create an
excellent checkering pattern.
A wide selection of cutters are available for jobs from scratch to
finishing of work begun by power equipment. Serrated type spacer cutters
remove wood faster made in 60° angle with just the right amount of
tip flatness to prevent digging into the wood; the use of 60° spacers is
recognized to be the most secure way to develop accurate spacing of the crossing
rows of checkering prior to the deepening process
to diamond point with other tools. These cutters hold the line through
dense or softer woods than 90° cutters. Grooves can be deepened
with angles of 60° or 90°.
The finishing (file type) PL and PS cutters cut crisp, clean grooves and are
especially useful for completing a fine job. Also, they are useful
in finishing work started with power tools and for refinishing worn
work. These are available in 60° or 90°.
Serrated and finishing cutters are 7/16" long secured to handles with
1/16" spirol pins. The PS cutter is 3/16" long and can be ground to
shorter length if required. It is secured with a 3/64" diameter spirol
pin or brad which can be clipped then peened.
Handles are made in three styles. H1 has a "see-thru" offset and is
supplied on the S2, S3, S4, K, KL, KR factory assembled tools. H2 has
a straight shank supplied on the VE, PL, BV and BC tools. H3 with a sharp bend
is used to hold the short cornering PS cutter. H1 and H2 handles can be used
with all cutters
except the PS.
Return to cutters